Ways of managing the battery in the dive computer designing

Questions, techniques, gear, safety. Also visit the NSS Cave Diving Section.

Moderator: Moderators

Ways of managing the battery in the dive computer designing

Postby luuna » Jan 12, 2017 1:43 am

I am designing an open source dive computer and have been looking for the simplest way of managing the battery which consists of three functions:
1) managing the charging of the battery
2) Regulating the output to 3.3v
3) providing accurate battery level to the processor (gas gauge).

I have not found any solutions that can do all this in one chip or for that matter, less than three (one for each of these functions).
Does anyone know of a good, simple solution? I want the device to worn on the wrist so board space is at a premium.
So far I am looking at Microchip's MCP73831 for charging, the TI's TPS61201 for regulating and TI's BQ27000 for "gas gauge" functionality. If you can point me in a better direction, I would appreciate it!

FYI: the device will use a 1200mAh Li-Po and use about 40ma while operating.
Reference:tMicrochip's MCP73831.pdfTPS61201.pdfBQ27000.pdf
luuna
New Poster
 
Posts: 1
Joined: Jan 12, 2017 1:27 am
  

Re: Ways of managing the battery in the dive computer design

Postby FW » Jan 20, 2017 8:37 am

There are better forums to ask this type of question. Try http://www.cavediver.net
Any opinions are personal.
User avatar
FW
Prolific Poster
 
Posts: 198
Joined: Oct 18, 2005 12:45 pm
Location: GA
Name: Forrest Wilson
NSS #: 16631
Primary Grotto Affiliation: Cave Diving Section
  


Return to Cave Diving Forum

Who is online

Users browsing this forum: No registered users