Securing a FoxFury to a helmet?

Discuss caving lights, packs, helmets, clothing, etc.
For rope and vertical equipment, go to the On Rope! forum.
Cave electronics enthusiasts can also visit the Communications and Electronics Section forum.

Moderator: Moderators

Securing a FoxFury to a helmet?

Postby Steven Johnson » Nov 9, 2005 1:12 pm

Finally got the change to try out my FoxFury underground. (Original "Signature", not newer "Performance" model.)

Love the light output, but it's really hard to get it to stay in place on my helmet (Ecrin Roc)... especially since the design only permits the headband to slip under the back two retaining clips (the front two are blocked by the light housing).

Aside from layers of duct tape, is there a better way to keep it in place on my helmet?
User avatar
Steven Johnson
NSS Hall Of Fame Poster
 
Posts: 309
Joined: Sep 5, 2005 8:48 pm
Location: Oakland, CA
NSS #: 49562
Primary Grotto Affiliation: Diablo Grotto
  

Headlamp support

Postby cavewine » Nov 11, 2005 1:12 pm

Alex (Inner Mt. Outfitters) sells a package of 4 little clips that slide onto headlamp straps, then clip onto the edge of a helmet. Very handy little devices for all sorts of lights. I think about 3-4$ for a pack.
Possibly found other places too, but definitely on IMO website.
David
:grin:
David Lyons
Former SUOC Cave Chair
Former NCC Trustee
Old Timer in Training
cavewine
Infrequent Poster
 
Posts: 10
Joined: Sep 6, 2005 8:25 am
Location: Syracuse, NY
  


Return to Equipment Forum

Who is online

Users browsing this forum: No registered users